Description: Please Read Full Description and look at All the Photos Before Ordering These are only for Gibson and will not fit Epiphone. Epiphone quick connects will Not work with these. Your Gibson quick connect pickups plug in to these. These solder to the pot, not the pickup. Photo #2 shows everything that is included (and it also comes with heat shrink tubing for the series link). Attention!!!! The speed of mail shipped from Boston is sometimes unpredictable.The efficiency of your state hub and local USPS plays a role as well. 95% of the time I ship the envelopes the day you order, but once the mail leaves my possession and into the hands of the post office, I have no control over how long it takes. Thanks Free USPS economy untracked shipping. Other shipping options available at checkout. (the detailed description starts here)Two (male pin/female housing) Quick Connects for Gibson neck & bridge pickups w/ heat shrink tubing for the series link These allow you to use Gibson Quick Connect pickups without the need of the Gibson control board/PCB. This is the (4 conductor+shield) "5 wire" Quick Connect that Gibson started using in (around) 2012. Made from 28 AWG 7 strand tinned copper wire and is about 4 inches long. See photos for the basic wiring/soldering diagram. Be sure to check out my other Gibson Quick Connect listings. If you don't see what you need in my listings, just ask, I probably have it. If there's ever a problem of any kind, please contact me, just try to be calm. I’ll get back to you as soon as I can and I will always fix it and make it right. Thanks Quick ’n Dirty Tips (always use safety glasses when working with tools) Even if you have an expensive stripper 😃, it can still be tricky for some people to remove insulation without a nicking a wire. When using strippers, just use them to make the cut.Then, pull the insulation off with your fingers.Don't use the strippers to yank the insulation off! If you don't have or don't feel like buying wire strippers, here's a couple of alternative stripping methods you might find helpful. Method 1Mark a straight line across all 5 wires with a marker Hold a non serrated butter knife or utility razor blade upside down (or a similar piece of metal with pliers)Heat the butter knife or non sharp side of the razor blade with a lighter or mini/pen torch Place one wire at a time on a flat surface Put the hot blade on the marked line of the wire and Twist the wire under it while pushing the blade forwardThere should be a perfect line melted around the insulation now Pull the little bit of insulation offYou should be good to go Method 2Hold the wire in one handRun the part of the wire that you want to strip over the flame of a cigarette lighter for 1 second or less (yes, literally 1 second or less) In a quick manner, pull the piece of insulation right offYou should be good to go Practice these methods on some scrap wire first, then practice on the ends of the quick connect wire. If you use these alternative stripping methods, it's of your own free will and I'm not responsible for screw ups.
Price: 14 USD
Location: Boston, Massachusetts
End Time: 2024-02-15T18:36:19.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
To Fit: Electric Guitar
Position: neck bridge
California Prop 65 Warning: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer, and chromium (hexavalent compounds), which is known to the State of California to cause birth defects or other reproductive harm. Lead is used in electronics as part of the soldering process as well as on some component terminals as part of alloys to make soldering possible.
Model: 5 Pin Connectors
Product Type: Pickups
Type: Humbucker
MPN: Does Not Apply
Brand: Gibson
